Use
Requirements for the set-up location
CAUTION
►
When selecting the installation location, ensure that the
appliances are not subjected to direct sunlight, vibration,
dust, heat, cold and moisture.
►
Do not set the appliance up in the vicinity of heat sources
such as radiators.
►
Mount the outdoor sensor at a maximum distance of 50 m
from the weather station. Ensure that there are no obstruc-
tions between the outdoor sensor and the weather station.
Otherwise, transmission can be disrupted.
♦
Both the weather station and the outdoor sensor can be
suspended from screws using the hangers
♦
Alternatively, you can fold out the foot
station and set it up on an even, horizontal surface.
Operating the outdoor sensor
♦
Open the battery compartment
ance by sliding the battery compartment cover
direction of the arrow.
♦
Insert two type AAA batteries into the battery compartment
as shown.
♦
Close battery compartment
lights up briefly and the current temperature, humidity and the
set radio channel (e.g. CH 1) are shown on the display
The control LED
that transmission is in progress.
│
GB │ IE
■
38
again. The control LED
then lights up once a minute to signal
and
of the weather
on the rear of the appli-
AHFL 433 A1
.
in the
.