Packing And Unpacking; Unpacking, Moving, Use And Storage; Setting To Work - Connection To The Power Supply; Warning Labels - Nilfisk cfm VHT437EXP Manual De Instrucciones

Packing and unpacking

Dispose of the packing materials in compliance with the laws
in force.
Figure 2
A B
MODEL
in. in.
VHT437EXP
(mm) (mm)
13 gal. 53.1 27.6
(50 L) (1350) (700)
26 gal. 53.1 27.6
(100 L) (1350) (700)
A B
MODEL
in. in.
VHT456EXP
(mm) (mm)
13 gal. 53.1 27.6
(50 L) (1350) (700)
26 gal. 53.1 27.6
(100 L) (1350) (700)
* Weight with packaging

Unpacking, moving, use and storage

Operate on flat, horizontal surfaces.
The load-bearing capacity of the surface the vacuum cleaner
is placed on must be suitable for bearing its weight.
02/2014
C
lbs.*
in.
(kg)
(mm)
71.1 451.9
(1805) (205)
71.1 458.6
(1805) (208)
C
lbs.*
in.
(kg)
(mm)
71.1 520.3
(1805) (236)
71.1 526.9
(1805) (239)
Setting to work - connection to the power
supply
WARNING!
■ Make sure there is no evident sign of damage to
the vacuum cleaner before starting work.
Before plugging the vacuum cleaner into the
■
electrical mains, make sure the voltage rating
indicated on the data plate corresponds to that of
the electrical mains.
■ Plug the vacuum cleaner into a socket with a
correctly installed ground contact/connection.
Make sure that the vacuum cleaner is turned off.
■ The plugs and connectors of the power supply
cords must be protected against splashes of
water.
■ Check the proper connection to the electrical
mains.
■ Use the vacuum cleaner only when the cord
that connects to the electricity mains is in good
condition (damaged cords could lead to electric
shock!).
■ Regularly check there are no signs of damage,
excessive wear, cracks or aging on the electric
cord.
WARNING!
When the device is operating, do not:
■ Crush, pull, damage or tread on the cord that
connects to the electrical mains.
Only disconnect the cord from the electrical
■
mains by removing the plug (do not pull the cord).
■ Only replace the power supply cord with one of
the same type as the original: SOOW. The same
rule applies if an extension is used.
■ The cord must be replaced by the manufacturer's
Service Center staff or by equivalent qualified
personnel.

Warning labels

Labels:
1. Warning: Explosion proof plug installed shall be certified
and be suitable for the hazardous area that the vacuum
is installed in
2. Warning: To reduce the risk of electric shock - do not use
outdoor
Caution: Open circuit before removing cover and keep
covers tight while circuits are alive
Warning: Explosion hazard - use only Nilfisk hose
Warning: The vacuum must be cleaned only with a damp
cloth
5
VHT437EXP - VHT456EXP
Figure 3
US
C404