Packing And Unpacking; Unpacking, Moving, Use And Storage; Setting To Work - Connection To The Power Supply - Nilfisk cfm T26 Plus Manual De Instrucciones

Packing and unpacking

Dispose of the packing materials in compliance with the laws
in force.
Figure 2
MODEL
T26 Plus
13 Gallons
26 Gallons
MODEL
T48 Plus
13 Gallons
26 Gallons
MODEL
T63 Plus
13 Gallons
26 Gallons
(*) Weight with packaging

Unpacking, moving, use and storage

Operate on flat, horizontal surfaces.
The load-bearing capacity of the surface the vacuum cleaner
is placed on must be suitable for bearing its weight.
02/2013
A (in) B (in) C (in) lbs.(*)
53.1 27.6 71.1 363.8
53.1 27.6 71.1 370.4
A (in) B (in) C (in) lbs.(*)
53.1 27.6 71.1 416.7
53.1 27.6 71.1 423.3
A (in) B (in) C (in) lbs.(*)
53.1 27.6 71.1 427.7
53.1 27.6 71.1 434.3
Setting to work - connection to the power
supply
WARNING!
■ Make sure there is no evident sign of damage to
the vacuum cleaner before starting work.
■ Before plugging the vacuum cleaner into the
electrical mains, make sure the voltage rating
indicated on the data plate corresponds to that of
the electrical mains.
■ Plug the vacuum cleaner into a socket with a
correctly installed ground contact/connection.
Make sure that the vacuum cleaner is turned off.
■ The plugs and connectors of the connection cables
must be protected against splashes of water.
■ Check that for proper connection to the electrical
mains.
■ Use the vacuum cleaners only when the cables
that connect to the electrical mains are in perfect
condition (damaged cables could lead to electric
shocks!).
■ Regularly check there are no signs of damage,
excessive wear, cracks or ageing on the electric
cable.
WARNING!
When the vacuum cleaner is operating, do not:
■ Crush, pull, damage or tread on the cable that
connects to the electrical mains.
■ Only disconnect the cable from the electrical mains
by removing the plug (do not pull the cable).
■ Only replace the electric power cable with one of
the same type as the original: SOOW. The same
rule applies if an extension is used.
■ The cable must be replaced by the manufacturer's
Service Centre staff or by equivalent qualified
personnel.
5
T26 Plus - T48 Plus - T63 Plus
US
C386