Cleaning And Maintenance - Woods DSC50FM Manual De Instrucciones

Operating Instructions
GB

CLEANING AND MAINTENANCE

Wood's dehumidifiers require cleaning
and change of filter, to maintain their high
dehumidifying capacity.
- The front grid can be vacuum-cleaned or
cleaned with a brush.
- The cooling coils are best cleaned with a
rag and warm water-be careful
- The fan motor is permanently lubricated
and requires no maintenance.
NOTE: Always disconnect the cord
before cleaning.
HINTS:
- Sometimes it may be useful to use a frost
guard or heater fan to make sure that the
temperature does not fall below +2˚C.
- For maximum dehumidifying power in
a room, it is recommended that the air
supply from outside and from adjoining
rooms is minimized – close doors and
ventilators.
- Put in the center of the room
- Increase temp. for faster dehumidification
( warm air carries more water.)
- Use frost guard if temperature falls below
+2°C
- Higher dehumidification in autumn /
summer because outside air is warm and
humid. (Absolute humidity is normally
higher).
WHEN THE DEHUMIDIFIER REQUIRES
SERVICING
If the dehumidifier requires servicing,
you must first contact the retailer. Proof
of purchase is required for all guarantee
claims.
10
GUARANTEES
2 year´s guarantee against faults in
manufacture. Note that the guarantee is
only valid for reciept of receipt.
NOTE! Get a 6-years warranty! Register
at warranty-woods.com and replace the
SMF-filter at least once a year. Please
visit woods.se for more information.
Recommended limits for use
Temp. DSC +2˚C to +35˚C
Relative humidity: 30% to 90%
Recommended
humidity level: appr. 50% RH
IMPORTANT! - Wood's
dehumidifiers must be connected
to an grounded power source.
The power source sould be
220V-240V 50Hz
06