Bodum BISTRO 11539 Instrucciones De Uso página 10

Ocultar thumbs Ver también para BISTRO 11539:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

BEFORE USING THE KETTLE
Clean the kettle before using it for
the rst time by lling it completely
(to the MAX mark) with water, boiling
the water, and then discarding the
water.
HOW TO USE THE KETTLE
Filling the kettle
Remove the kettle from its base (6).
Open the lid (1), ll the kettle with
water to the desired level then close
the lid. The kettle must contain a
minimum of 0.25 l and should be
lled no higher than the MAX mark.
This prevents it from switching
off before the water has boiled or
reached the required temperature.
Connecting to the electrical supply
After lling the kettle, place it on its
base (6). Check the kettle is properly
seated on the base.
Connect the kettle to the electrical
supply; an acoustic signal indicates
that it is ready.
Now select the required water tem-
perature by turning the temperature
selection knob (8) and press the on/
off button (7). This will ash until the
water either reaches the required
temperature or boils, at which point it
will extinguish.
An acoustic signal indicates when the
water has reached the selected tem-
perature. The water can now be used.
Note: to change the required tem-
perature of the water while it is
heating, simply turn the temperature
selection knob (8).
Note: different teas require different
brewing temperatures. Brewing a deli-
cate variety at too high a temperature
4
can make it taste bitter. The BODUM®
water kettle with adjustable tempera-
ture settings is ideally suited to pre-
paring any type of tea. There are ve
temperature settings to choose from.
(60°C; 70°C; 80°C; 90°C and boil)
«Keep warm» function
To keep the water at the required
temperature for 30 minutes, press
the «keep warm» button (9).
The «keep warm» button will remain
illuminated until the kettle is removed
from its base (6), the button is
pressed again, or 30 minutes have
expired.
Note: The «keep warm» function
only works in combination with ON/
OFF-button. The «keep warm» button
(9) can be pressed before switching
the kettle on (You need to press the
ON/OFF button within 5 seconds
after pressing the «keep warm» but-
ton), or while the water is heating.
After the water has reached the
required temperature, it is needed to
press «keep warm» button and ON/
OFF switch again.
Switching off
The kettle switches off automatically
when the water comes to the boil or
reaches the required temperature.
The kettle can be switched off at any
time by pressing the on/off button
(7). The kettle switches off automat-
ically when it is removed from its
base.
Pouring the water
Holding the kettle by its handle, lift
it from its base (6). Check the kettle
remains upright while lifting it from
its base (6).

Publicidad

Tabla de contenido
loading

Tabla de contenido