Date/Time Setting - Sytech Easy Talk SY-1490 Manual Del Usuario

Note: If the unit is in locked mode, the "EXT, PREFIX" option will not be shown.

Date/Time setting

When the unit is on on-hook or off-hook state, press the SET/ST key and then press the UP/+ key five times.
The LCD will display DATE/TIME. Press the SET/ST key for the year digits to flash. Use the UP/+ or DOWN/
－ keys to change the year, then press SET/ST key to enter the setting of the month. Repeat the operation to
set the month, day, hour and minute by turn. The LCD will automatically display the week of the corresponding
day. The current date and time will be updated by the FSK Caller ID signal while the year setting remains
unchanged.
Alarm clock setting
When the unit is on on-hook or off-hook state, press the SET/ST key to enter the menu settings. Press the
UP/+ key six times for the screen to display ALARM. Press the SET/ST key to confirm. The screen then shows
"OFF" on the top line, "-1- 12-00" and "1" flashing on screen.
"-1-" indicates ALARM1. The phone can set 5 different alarms
"OFF" indicates the alarm is set to off mode.
"12-00" indicates the alarm clock time
Use the UP/+ or DOWN/－keys to select the alarm clock group from 1 to 5. Press the SET/ST key and
"OFF" flashes. Use the UP/+ or DOWN/－keys to select "ONE TIME" (Rings only once) or "P.D" (Repeats
every day). When either "ONE TIME" or "P.D" is selected, press SET/ST key and "12" flashes. Press the UP/+
or DOWN/－keys to adjust the alarm "hour". Press SET/ST key to confirm and set the alarm "minute" in the
same way.
Set the rest of the alarms using the same method above. If you wish to turn off the alarm, set it to "OFF".
Once the alarm has been set and the alarm function has been selected to ("ONE TIME or "P.D"), the alarm
will ring during 50 seconds and can be stopped at any time by pressing any key. When there is an incoming
call during the alarm, the unit will stop the alarm tone and give preference to the call.
Flash time setting
When the unit is on on-hook or off-hook state, press the SET/ST key and then press the UP/+ key seven times.
The LCD will display "FLASH". Press the SET/ST key and you will see "100" flashing on the LCD. Use the
UP/+ or DOWN/－ keys to select the flash time at 100, 120, 180, 270, 300, 600 or 1000ms. Press the SET/ST
key to confirm.
Pause time setting
When the unit is on on-hook or off-hook state, press the SET/ST key and then press UP/+ key eight times. The
LCD will display "PAUSE". Press the SET/ST key "3.0" will be flashing on the LCD. Use the UP/+ or DOWN/
－ keys to select the pause time at 1.0s, 2.0s, 3.0s or 4.0s. Press SET/ST key to confirm.
LCD contrast adjusting
12