Panasonic EYFGA1A Manual De Instrucciones página 12

Tightening Torque Setting
EN EN
See the illustration
1. Open the shutter, (1) in the illustration
with the clutch setting handle, () in the illus-
tration .
10
Engage the ribs on the main unit with the
ribs on the clutch setting handle (on the
short side) and turn clockwise.
See the illustration
. Insert the 3 ribs on clutch setting handle
(on the long side) into the shutter holes.
User should insert the highlighted wider
rib into the highlighted hole.
To increase clutch torque, turn the clutch
setting handle clockwise. To decrease
clutch torque, turn the clutch setting han-
dle counterclockwise.
See the illustration
3. Close the shutter with the clutch setting
handle (on the short side) by turning coun-
terclockwise.
NOTE
• Be sure to close the shutter after setting
has been completed in order to prevent
dust from entering.
• Illustration
the getting at #0 and #40.
Tightening torque chart (reference
values)
See the illustration
• Refer to the tightening torque chart, in illus-
tration 13 , to select torque settings.
• The values in the chart are just for reference
and measured under the conditions defined
by Panasonic. During actual work, values
will vary based on operating conditions.
Measurement conditions
As defined by Panasonic
10
11
12
is an example of clutch
12
13
CAUTION:
• Do not use the tool without prior verifi-
cation of its tightening torque setting to
avoid excessive or inadequate torque.
• Always finish rundown with the tool's trig-
ger switch fully depressed. Otherwise, it
,
10
may affect torque accuracy.
Configuring Tool Settings
RPM adjustment setting
1. Turn off the control panel.
• If the control panel is on, remove and
then reinsert the battery pack.
. Depress the switch while pushing the
button and then release both the
ton and the switch.
• After the LED light and tightening con-
firmation lamp have illuminated and the
buzzer has rung, the control panel will
flash and change to configuration mode.
See the illustration
NOTE:
• The control panel will turn off if the tool
is not operated for a period of 5 min-
utes.
See the illustration
3. Press the
clutch setting that is appropriate for the
work being performed.
As the
is pressed
78
RPM
80 800
75 750
45 450
15 150
- 1 -
14
15
and buttons to select the
button As the
is pressed
79 80 15
77 ... 17
GA1 GA
Setting not
available
Setting
available
but-
button
16
GA3