Buzzer Setting - Panasonic EYFGA1A Manual De Instrucciones

4. Press the OK button to accept the new
EN EN
setting.
NOTE:
• When the remaining number of tighten-
ing operations is 10,000 or less, the
display will alternate between "Setting"
and "1." When the remaining number
of tightening operations reaches 0, the
value "0" will flash on the display.
To reset the count to 0, initialize the tool
(see page 15).
• The maximum tightening operation
count value is 990,000. Operations in
excess of 990,000 will not be counted.
Radio signal range limitation function
on/off setting (EYFGA1AR, EYFGA2AR,
EYFGA3AR)
1. Set the tool to setting configuration mode.
(See page 1.)
. Press the C button three times.
• Radio signal range limitation function
on/off setting value will be displayed.
See the illustration
3. Press the
nal range limitation function on/off.
Radio signal
Display range limitation
function mode
C0 OFF
C1 ON
4. Press the OK button to accept the new
setting.
NOTE:
• For more information about how to register
the tool and Assembly Qualifier, see the
Assembly Qualifier instruction manual.
16
or buttons to set radio sig-
Status
Tool is operational in the
absence of communica-
tions with the Assembly
Qualifier.
Tool is not operational
in the absence of com-
munications with the As-
sembly Qualifier.

Buzzer setting

• You can select from three buzzer modes.
1. Set the tool to setting configuration mode.
(See page 1.)
. Press the A button once.
• The current setting value will be dis-
played.
3. Press the
desired value.
Display
b0
b1 Buzzer accompanying green indicator
b Buzzer accompanying red indicator
4. Press the OK button to accept the new
setting.
LED light setting
• You can select from two LED light modes.
1. Set the tool to setting configuration mode.
(See page 1.)
. Press the B button once.
• The current setting value will be dis-
played.
3. Press the
desired LED mode.
Display
L1 Linked to LED light button
L Linked to trigger switch operation
4. Press the OK button to accept the new
setting.
Speed control function
• The speed (RPM) can be changed with the
amount of depression of the trigger.
1. Set the tool to setting configuration mode.
(See page 1.)
. Press the B button three times.
• The setting value will be displayed.
3. Press the
setting to ON or OFF.
Operation
P0
P1
4. Press the OK button to accept the new set-
ting.
- 14 -
or buttons to set the
Function
No buzzer
or buttons to set the
Function
or buttons to change the
Function
Speed control ON
Speed control OFF