Taking Into Operation - Truma DuoComfort Instrucciones De Uso Instrucciones De Montaje

b
a
DuoC omfo
rt
Truma offers a remote
indicator as an accessory
(part no. 50210-01) to permit
reading of the operating cyl-
inder's status from inside the
vehicle.

Taking into operation

• For example, turn control knob
(a) to the left until it stops
(left connection is operating
cylinder).
• Connect gas cylinders and
make sure all hose connec-
tions are in good condition.
• Open the valves on both gas
cylinders. The display in the
mica window will turn green.
• If SecuMotion is installed, firm-
ly press the green reset button
on the high pressure hose
and bring SecuMotion into
operation (see „SecuMotion
Operating instructions").
Changeover
As soon as the pressure in the
operating cylinder falls below
0.5 bar, the valve automatically
switches over and begins tak-
ing gas from the second gas
cylinder. The display in the mica
window turns red.
In extreme cold or when a
large amount of gas is con-
sumed from the cylinder over a
long period of time, the gas pres-
sure may fall below 0.5 bar even
though there is still some gas left
in the cylinder. This may result in
gas being taken from both gas
cylinders simultaneously.
If needed, you can change the
position of the control knob at
any time.
Always turn control knob (a) as far
to the left or right as it will go (an
intermediate position will cause
gas to be removed from both gas
cylinders simultaneously).
Removal status
In the normal position (operating
cylinder on the left, reserve cyl-
inder on the right), the following
display will be seen:
11