Operation Instructions - Truma ZUE Instrucciones De Uso

Operation instructions

The heater can be switched
on or off at the control panel
or timer. If the heater is to be
switched on at the timer the
operation switch on the control
panel must be „OFF".
Following a interruption of the
power supply (e.g. removing
or charching the battery), the
time on the display flashes. A
programming of the heater is
only possible after entering the
current time.
Immediate switch-on
of the heater
Independent of any programmed
time, the heater can be switched
on or off with the key
12
Entering the current time
Press the key
the display flashes. Set current
time with the keys
the keys are pressed for longer
than 5 seconds the fast forward
is initiated.
Entering the
current weekday
Press the key
the display flushes, after approx.
5 seconds the day indicator
flashes. Set the current weekday
with the keys
Programming the
switch-on times
.
Press key
the programme number 1 appears.
and hold until
or . If
and hold until
or .
once, on the display
Enter the requested switch-on
time with the keys
approx. 5 seconds the week-
day indicator flashes. Enter the
requested switch-on weekday
with key . Press key
again to transfer the data to the
memory. On the display appears
programme number 2. Enter the
requested switch-on time and
weekday as before and press
key once again. The programme
number 3 is set as before.
After pressing key again no
programme number shows on
the diplay and the data is in the
memory.
In order to avoid having to
carry out reprogramming
for every weekday in a situation
in which the same heating time
recurs each day, the next pos-
sible weekday is automatically
displayed on memory spaces
1 and 2. The weekday can be
explicitly set at memory space 3.
or . After
once