Battery Safety Instructions - Epson WF-100 Guía De Referencia Rápida

■
If you use an extension cord with the printer, make sure the total ampere rating of the devices
plugged into the extension cord does not exceed the cord's ampere rating. Also, make sure the
total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet's
ampere rating.
■
Always turn off the printer using the power button, and wait until the power light stops
flashing before unplugging the printer or cutting off power to the electrical outlet.
■
Place the printer on a flat, stable surface that extends beyond its base in all directions. It will not
operate properly if it is tilted or at an angle.
■
Leave enough space in front of the printer for the paper to be fully ejected.
■
Avoid locations that are subject to rapid changes in heat or humidity, shocks or vibrations,
or dust.
■
Do not place the printer near a radiator or heating vent or in direct sunlight.
■
Leave enough room around the printer for sufficient ventilation. Do not block or cover
openings in the case or insert objects through the slots.
■
Keep the printer away from potential sources of electromagnetic interference, such as
loudspeakers or the base units of cordless telephones.
■
Do not touch the flat white cable inside the printer.
■
Do not move the print head by hand; this may damage the printer.
■
Do not spill liquid on the printer or AC adapter and do not handle the printer or AC adapter
with wet hands.
■
Do not use aerosol products that contain flammable gases inside or around the printer. Doing
so may cause fire.
■
Except as specifically explained in your documentation, do not attempt to service the printer
yourself.
■
Unplug the printer and refer servicing to qualified service personnel under the following
conditions: if the power cord or plug is damaged; if liquid has entered the product; if the
product has been dropped or the case damaged; if the product does not operate normally or
exhibits a distinct change in performance. Adjust only those controls that are covered by the
operating instructions.
■
If damage occurs to the plug, replace the cord set or consult a qualified electrician. If there are
fuses in the plug, make sure you replace them with fuses of the correct size and rating.
■
Leave the ink cartridges installed. Removing the cartridges can dehydrate the print head and
may prevent the printer from printing.
■
Before transporting the printer, make sure that the print head is in the home (far right) position
and the ink cartridges are in place.
■
The printer includes a built-in battery. When disposing of the printer, make sure to follow local
battery disposal regulations.

Battery Safety Instructions

■
If the battery is not fully charged within the specified time, stop charging. Otherwise, the
battery could become hot, emit smoke, rupture, or catch fire.
■
Do not place the product in a microwave oven or high-pressure container. Otherwise, the
battery could become hot, emit smoke, rupture, or catch fire.
34
Notices