Fitting The Blade - Sima COBRA MKNO Manual De Instrucciones Original

4.6 FITTING THE BLADE

You will always get better results by using the most appropriate blade for the surface you are cutting. The
blades are cooled by water. The cooling s ystem guarantees the correct flow for the cooling of the disc.
Installing the blade.
1. Disconnect the refrigeration system.
2. Loosen the nut that holds the blade protection in place. The nut loosens in the same direction as the
movement of the blade.
3. Start with the hexagonal spanner to hold the nut in place and then use the rod to loosen as pictured.
4. Remove the bolt and the exterior flange and fit the blade against the inside flange.
5. Re-fit the exterior flange.
6. Put the disc protector back in its place and tighten the screws..
7. Reconnect the cooling system.
• The nut loosens in the same direction as the direction of the blade.
• Never start or use the machine without the blade protector fitted.
• Make sure that the blade cutting direction is correct. Match the arrow on the blade and the arrow on
the blade protector and make sure they are pointing the same way.
• Make sure that the blade is flush on the flange before tightening the screw.
9
ENGLISH