Battery For The Transmitter - Silvercrest WD1610 Manual Del Usuario

Wireless Door Bell WD1610
polarity (+ and -). The correct polarity is
labelled on the batteries and inside the
battery compartment.
- Slide the battery compartment cover onto
the receiver housing.

Battery for the Transmitter

To open the transmitter housing, use a flat
-
screwdriver. Insert the screwdriver carefully
into the transmitter housing side and press
it slightly inwards to release the nose latch
(8). Then pull the upper housing piece
upwards.
Insert the supplied A23-sized 12 V battery
-
into the upper transmitter housing piece.
The correct polarity is labelled on the
battery and inside the transmitter housing.
Replace the upper housing piece onto the
-
transmitter base unit.
86 - English
You may also leave the base unit piece
separated if you want to mount the
transmitter on the wall.