Mounting The Transmitter - Silvercrest SFS 52 B2 Instrucciones De Uso

Ocultar thumbs Ver también para SFS 52 B2:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

If the synchronisation has been a success, the
receiver notifies you of the programmed call signal.
Should the receiver not react as described, repeat the
synchronisation.
NOTE
To cancel synchronisation between the transmit-
ter and the receiver, you need to press and hold
the synchronisation button
seconds.
Pull the receiver out of the mains socket and wait
about 10 seconds so that all connections bet-
ween the transmitter and receiver are terminated.

Mounting the transmitter

Select a suitable positioning for the sender, close
to your outer door.
Mark the positions for the required drill holes
with the help of the mounting plate
the holes for the supplied wall plugs
drill).
Push the wall plugs into the drill holes and screw
the mounting plate
screws
Push the transmitter onto the mounting plate
until it clicks audibly into place.
SFS 52 B2
.
onto the wall using the
GB │ MT
for about 5
and drill
(5 mm
 67

Publicidad

Tabla de contenido
loading

Tabla de contenido