Seat (Grammer Msg85); Weight Adjustment; Height Adjustment - Jacobsen AR3 Manual De Seguridad, Funcionamiento Y Mantenimiento

ADJUSTMENTS 9

9.10 SEAT (Grammer MSG85)

The seat can be adjusted for leg reach, back rest
angle and operator weight to provide a comfortable
position for operating the machine.
A. FORE AND AFT ADJUSTMENT
To Adjust:
The position of the adjusting lever (B) is on the right
hand side of the seat below the seat cushion . By
pulling the lever up, the seat can be slid backwards
and forwards, when in the desired position release
the lever to locate in one of the pre set positions.
B. BACK REST ADJUSTMENT
To Adjust:
The position of the release lever (B) is on the left
hand side of the seat. While sitting on the seat pull
the release lever upwards to release the back rest.
(The back rest is spring loaded to fold onto the seat
cushion.) Lean back to obtain the desired position
for the back rest and release the lever to locate in
one of the pre set positions.
C. WEIGHT ADJUSTMENT
To Adjust:
The position of the operator weight adjust lever (C)
is on the front of the seat. To Change the operator
weight sitting pull the lever out and rotate the lever
while sitting on the seat.
D.

HEIGHT ADJUSTMENT

To adjust:
When sitting on the seat the height can be adjusted
by holding the edge of the seat cushon, pushing your
weight down and lifting as the cushon as the
suspension returns to its normal position. There are
three pr-set positions, once the heighest has been
achived the seat returns to its lowest position.
NOTE:The seat is fitted with a microswitch to sense
operator presence.
When the machine is fitted with an OPS frame a lap
belt is fitted and should be worn at all times
en-59