Samsung NX58H9950W Serie Manual Del Usuario página 47

Maintenance
CAUTION
• The starter electrodes are not removable. Do not attempt to remove them by
force.
• Make sure all burner components (heads and caps) are reinstalled properly.
They are stable and rest flat when installed properly.
• To avoid chipping, do not bang grates and caps against each other or hard
surfaces such as cast iron cookware.
• The burner spreader can be blocked by food or dust. Clean the spreader if it
appears blocked. If you clean the spreader with water, assemble it only after
it is completely dry. If the spreader is wet, it might prevent the burners from
igniting.
Self-cleaning
This self-cleaning oven uses high temperatures (well above cooking temperatures)
to burn off leftover grease and residue completely or reduce them to a finely
powdered ash that you can wipe away with a damp cloth.
CAUTION
• Do not leave small children unattended near the gas oven during the self-
cleaning cycle. The outside surfaces of the gas oven can get extremely hot.
• Some birds are extremely sensitive to fumes from a self-cleaning gas oven.
Relocate birds to a well-ventilated room away from the gas oven.
• Do not line the oven, oven racks, or oven bottom with aluminum foil. Doing
so will result in poor heat distribution, produce poor baking results, and cause
permanent damage to the oven interior. The aluminum foil will melt onto and
adhere to the interior oven surfaces.
• Do not force the oven door open during the self-cleaning cycle. This will
damage the automatic door-locking system. The door automatically locks when
the self-cleaning cycle is started and stays locked until the cycle is cancelled
and the oven temperature is below 392 °F.
• Use caution when opening the oven door after the self-cleaning cycle. The gas
oven will still be VERY HOT and hot air and steam might escape when the door
is open.
• Wipe off any excess spillage before using the self-cleaning operation.
• Do not use oven cleaners. Commercial oven cleaners or oven liners should
NEVER be used in or around any part of the oven. Residue from oven cleaners
will damage the inside of the oven during a self-cleaning operation.
To perform the self-cleaning cycle
Make sure the door lock is released. Remove all racks from the oven cavity.
1. Make sure the oven door is unlocked and closed completely.
2. Press the Self Clean button, and then select the cleaning time. See the table
below.
Once
2-hour cycle
3. Press the START/SET button. The oven door is locked and the oven begins to
heat up.
When the cycle is complete, the oven beeps 6 times. The door will remain
locked and the Lock icon will blink until the oven temperature falls below
392 °F (200 °C).
4. When the Lock icon changes to an open lock, you can open the oven door. The
Lock icon changes to an open lock when the oven temperature drops below
392 °F (200 °C).
5. Press the OFF/CLEAR button to display the time of the day.
CAUTION
Do not use the surface burners while the gas oven is performing a self-cleaning
cycle.
5
3
2
Twice Three times
3-hour cycle 5-hour cycle
English 47