NEC WT615 Guia De Instalacion página 11

Note on Startup screen (Menu Language Select screen)
When you first turn on the projector, you will get the Startup menu. This menu gives you the opportunity to select one
of the 21 menu languages.
To select a menu language, follow these steps:
1. Use the SELECT
21 languages for the menu.
2. Press the ENTER button to execute the selection.
The menu will be displayed in the language you
have selected.
3. To close the menu, press the EXIT button.
NOTE: Immediately after turning on the projector, screen flicker may occur. This is not a fault. Wait 3 to 5 minutes until the lamp
lighting is stabilized.
• When the Lamp mode is set to Eco, the Lamp indicator will light green.
• If one of the following things happens, the projector will not turn on.
- If the internal temperature of the projector is too high, the projector detects abnormal high temperature. In this
condition the projector will not turn on to protect the internal system. If this happens, wait for the projector's
internal components to cool down.
- When the lamp reaches its end of usable life, the projector will not turn on. If this happens, replace the lamp.
- If the lamp fails to light, and if the STATUS indicator flashes on and off in a cycle of six times, wait a full minute and
then turn on the power.
- When the mirror cover is closed.
- If the temperature sensor detects excessive heat in the bottom of the mirror or in the light path, the projector will
not turn on. Remove objects such as dust from the bottom of the mirror.
- The projector has a sensor which detects an object in front of the largest mirror or in the light path. If the sensor
detects any object, the projector will not turn on. Remove the object.
- Do not illuminate the projector with strong light source such as halogen lamp.
Doing so can cause the object detection sensor to malfunction, resulting in the projector not turning on.
• Immediately after turning on the projector and displaying an image, you cannot turn off the projector for 60 seconds.
or button to select one of the
Cabinet controls
ENTER
AUTO
ADJUST
STAND BY
ENTER
AUTO
ADJUST
ON/
STAND BY
ENTER
AUTO
ADJUST
ON/
STAND BY
E-7
Remote control
SELECT
MAGNIFY
EXIT
3D
REFORM
POWER
ON/ STATUS
LAMP
SELECT
MAGNIFY
EXIT
3D
REFORM
POWER
STATUS
LAMP
SELECT
OFF
MAGNIFY
EXIT
3D
REFORM
POWER
STATUS
LAMP
OFF ON
POWER
LASER
PAGE
UP
POINTER
DOWN
OFF ON
POWER
LASER
PAGE
UP
POINTER
DOWN
ON
POWER
LASER
PAGE
UP
POINTER
DOWN