Turning On The Projector - NEC WT615 Guia De Instalacion

Turning on the Projector

NOTE:
• The projector has two power switches: a main power switch and a POWER (ON/STAND BY) button (POWER ON and OFF on the
remote control).
• When plugging in or unplugging the supplied power cable, make sure that the main power switch is pushed to the off ( )
position. Failure to do so may cause damage to the projector.
1. Open the mirror cover. See page E-5 for more
details.
2. To turn on the main power to the projector, press the
Main Power switch to the on position ( I ).
• The POWER indicator will light orange.
3. Press the POWER (ON/STAND BY) button on the
projector cabinet or POWER ON button on the
remote control for a minimum of 2 seconds, when
the PWOER indicator turns a steady green the
projector is ready to use.
• After you turn on your projector, ensure that the
computer or video source is turned on.
NOTE: If you turn on the projector immediately after the lamp
is turned off or when the temperature is high, the fans run
without displaying an image for some time and then the
projector will display the image.
NOTE: When no signal is available, a blue, black or logo screen is displayed.
Cabinet controls
ENTER EXIT
3D
REFORM
AUTO
ADJUST
POWER
ON/
STATUS
STAND BY
LAMP
Standby
LAMP
STATUS
POWER
STAND BY
Steady orange
light
Press this button for a
minimum of 2 seconds.
E-6
POWER
STATUS
LAMP
Remote control
OFF ON
POWER
LASER
PAGE
MAGNIFY
UP
POINTER
DOWN
Blinking for
one minute
LAMP
STATUS
POWER
ON/
Blinking green Steady green
light
Power On
LAMP
STATUS
POWER
light