Bosch BCM8450UC Manual De Uso Y Cuidado página 21

■ Turn the control ring and select "00h15m".
■ Press A. [ Save ] and [ D o not save ]
appears.
■ Press [ Save ]. The setting is saved.
The drink selection appears on the display.
Note:
Press A to exit the menu at any time. If
no entry is made within approx. 30 seconds,
the menu closes automatically and the
settings are not saved.
The following settings can be made:
Language
Set the desired language to show the
display texts.
Water hardness
Set this to the local water hardness.
Level "1 (soft)" to "4 (very hard)" can be
selected. The preset water hardness is
"4 (very hard)".
Note:
It is important to set the water hardness
correctly to enable the appliance to accu-
rately indicate when the descaling program
should be run.
You can check the water hardness using
the enclosed test strip or by asking your
local water supplier. If a water softening
system is installed in the house, please
select the "Softening device" setting.
Water filter
If a water filter is inserted, renewed or
removed, the setting "Insert", "Replace" or
"Remove" must be made in the menu.
Note:
A water filter lowers limescale deposits,
reduces impurities in water and improves
the coffee taste.
Water filters are available from retail outlets
or from customer service (see the section
"Accessories").
Inserting or renewing a water filter:
A new water filter must be rinsed before it
can be used.
■ Turn the control ring to select either
"Insert" or "Replace".
■ Press the water filter firmly into the
opening of the water tank.
■ Fill the water tank with cool water up to
the "max" mark.
■ Remove the milk tube from the milk
container and close the door.
NOTICE:
Do not jam the tube when closing the door.
■ Place a container with a capacity of 17 oz
under the outlet .
■ Press C.
Water will now flow through the filter to
rinse it.
■ Then empty the container.
The appliance is ready for use again.
Note:
Rinsing the filter simultaneously activates
the setting for the change filter display.
The filter is no longer effective when the
"Replace water filter" display appears, or at
the latest after two months. It needs to be
replaced for reasons of sanitation and to
prevent a build-up of limescale (which could
damage the appliance).
■ If a new filter is not inserted, select the
setting [ R emove ] and press C.
The message "Remove filter, reinsert
water tank, close door" appears.
Note:
If the appliance has not been used for a
prolonged period (for example, while you
are on vacation), the existing filter should
be rinsed before the first time the appliance
is used again. To do this, simply dispense a
cup of hot water.
Detailed information about the water filter
can be found in the manual supplied with
the filter.
Menu en
17