Agitator Brush Roll - Hoover WindTunnel Manual Usuario

Agitator brush roll
When agitator brush roll brushes on
the powered pet hair cleaning tool
are worn, the agitator brush roll should
be replaced. Ask for HOOVER part
No. 48414088.
How to replace
Q1. Remove tool from hose and
turn it so bottom faces up. Press
the latches on either side of tool and
remove bottom plate (A).
Q2. Unscrew the two Phillips
screws and remove belt guard
(B).
3. Remove agitator })rush roll
including end plates (C) and
discard.
4. Inspect belt to ensure that it is in
good condition. If belt is cracked,
gouged or broken, replace it (see fol-
lowing section).
D
B
\
5. Insert agitator })rush roll
through belt and position belt
over gear teeth (D) on agitator })rush
roll.
6. With curved ends down,
slide end plates (C) of agitator
})rush roll into slots (E) on tool.
7. Replace belt guard (B) mak-
ing sure not to pinch })rush bris-
tles in guard. Turn agitator })rush roll,
to make sure it rotates freely.
Replace and tighten screws.
14