Installation Instructions - Midea MAE50-S1102 Manual De Usuario

INSTALLATION INSTRUCTIONS

REMOVE PACKAGING
Remove packaging, foam cushions, and bottom cardboard.
•
• Open the washer door and take out the accessories.
• Use of washer with the foam cushion is strictly prohibited.
PLACEMENT OF UPPER WATER DRAIN HOSE
T he height of the drain hose (A ) should be betw een ~34 to
40".Its diameter (B ) should not be less than 1.20", and its
flow capacity should not be less than 40 L/Min.
B efore starting the w asher, users should properly hang the drain
pipe ~34 to 40"above the floor.
INSTALLATION OF WATER INLET HOSE
• Place the water inlet hose screw onto the tap.
• Tightly screw the other end of the hose to the
water inlet valve using the rubber seal ring
inside.
NOTE:When tightening the clamping nut, evenly
apply force and avoid twisting the water inlet valve
to prevent breakage of the water inlet valve joint.
F OR U P P E R D R A IN S Y S T E M ON LY
Clamping nut
Water inlet hose
ONLY FOR WATER INLET HOSE
WITH DOUBLE THREADED SCREW
Foam
Cushion
B ase
34~40''
8