Seat 6J0055204 Instrucciones De Montaje página 8

GB ELECTRICAL INSTALLATION KIT OF THE TOW HOOK
Warning
The electrical installation kit of the tow hook is determined for professional assembly only. The
assembly requires the use of specific tools and shop documents and therefore this part cannot
be sold to the end-user without assembling.
Electric installation kit contains:
Part name
Complete harness of electric installation for tow hook
Control unit
Socket 13.pol.
Fuse 5 A
Fuse 15 A
6 poles block 6Q0 972 706
5 poles block 1J0 973 333
2 poles block 893 971 632
Screw M5 x 16
Expanding nut N.908.338.01
Screw N.909.652.02
Tightening bands
Stickers
Protective foam part
List of specific tools:
Set of punctures
Diagnostic equipment
Dismount:
- Rear bumper
- Boot area, covering and side covering and covering of rear cross side
- Covering of left sill of the car
- disconnect the "minus pole" of the battery, release the fuse box and disconnect the BCM unit
- For vehicles without Start & Stop and / or without automatic lights, dismount the instrument
panel and the lights switch.
Installation in the boot area and the rear bumper side:

 Dismount the cable harness of License plate lighting and the light-bulb sockets in the
bumper side.
 Remove the rubber grommet and pull through the harness of electro installation into the
vehicle.
 Pull out the connectors of the harness with the light-bulb socket and the connector of tow
bar from the boot. In some case, a connector for Park Pilot can be present.
 Fix the harness into the hole with the grommet and ensure its water-proof.
 With the tightening bands fix the outer harness of installation to the tow-bar (See 1). In
case of Park Pilot presence, fix the proper connector to its holder. WARNING: the cables
must be oriented into the vehicle.
8
Pcs
1
1
1
1
3
1
1
1
3
2
2
10
4
3