Ariens LM21SW Classic Manual Del Propietario - Operador página 12

Standard Models
To change cutting height, move cutting height
levers one notch at a time on each wheel to
set desired height (Figure 5).
NOTE: Each wheel on mower must be set at
the same height for a level cut.
Rear
low
High
Low
High
Front
1. Cutting Height Lever
Figure 5
Swivel Wheel Models
(911184)
To change front wheel cutting height, insert
height adjuster pin into the holes that match
the desired cutting height and fasten with key
ring (Figure 6).
To change rear wheel cutting height, move
cutting height levers one notch at a time to
set the desired cutting height.
Low
Front
!
3
1. Cutting Height Lever
2. Height Adjuster Pin
3. Key Ring
Figure 6
OPTIONAL CONTROLS
Primer Bulb
Push the primer bulb in to add fuel for easier
engine start.
GB- 12