Publicidad
Idiomas disponibles
Idiomas disponibles
To decrease
the gap between
the friction disc
and the aluminum
drive p late:
1.Loosen the upper cable n ut o nthe wheel
drive c ontrol cable, and then tighten the
lower cable n ut a gainst the adjuster
bracket. See Figure 18.
To decrease thegap,
loosen the upper cable
nut.
Then t ighten the lower
cable n ut a gainst the
bracket.
Figure 18
2.Check the adjustment
and readjust as
needed.
NOTE: Ifthe gap between
the friction disc
and aluminum
drive p late c annot beadjusted
tothis tolerance,
take the unit t oan
authorized
service dealer forrepairs.
SPEED CONTROL BELL CRANK
(Self-Propelled
Models)
The speed control bell crank holds the speed
control rod in position after a speed has been
set. The spring washers may become loose
with normal wear. If the speed control rod
does not stay firmly in position, adjust the
speed control bell crank. See Figure 19.
To adjust:
1. Remove cover, fully compress the
helical spring lock washers with lock nut
and then back lock nut off, one quarter
turn.
2. If the speed control rod is still too loose,
tighten lock nut by small increments until
it holds its position. Tightening the lock
nut too much will not allow the speed
control rod to move at all.
3. Align notch in left hand side of cover with
bolt and secure with knob.
_2
OMI670
1. Lock Nut
4. Swivel
2. Helical Spring
5. Hair Pin
Lock Washers
6. Speed Control
3. Speed Control
Rod
Bell Crank
Figure 19
GB - 23
Publicidad
Capítulos
