Handlebar Switches - Yamaha BANSHEE Manual Del Propietário

w
1. Lights switch "LIGHTS"
1. Contacteur d'éclairage
"LIGHTS"
1. Interruptor de luces
"LIGHTS"
q
2. Engine stop switch
"ENG. STOP"
2. Coupe-circuit du moteur
"ENG. STOP"
2. Interruptor de paro del
motor "ENG. STOP"
EBU00053

Handlebar switches

EBU00054
Engine stop switch "ENG. STOP"
Make sure that the engine stop switch is in the
"RUN" position. The engine stop switch controls
ignition and can be used at all times to stop the
engine, especially in an emergency. The engine
will not start or run when the engine stop switch
is turned to "OFF".
EBU00736
Light switch "LIGHTS"
Turn the switch to the "LO" position to switch on
the low beam and the taillight.
Turn the switch to the "HI" position to switch on
the high beam and the taillight.
Turn the switch to the "OFF" position to switch off
the headlight and the taillight.
NOTE:
The headlight and the taillight can be turned on
only when the engine is started.
4-3