System Start-Up: Self-Teach - Aprimatic R1-24 Instrucciones Para La Instalación, Uso Y Mantenimiento

Electrical connections
2.4.2 UNIT COMPONENTS AND CONNECTIONS
RS232 serial connector / Urmet interface connector
J1
removable terminal board - power for two 24 V DC motors - 2-wire cables with minimum section of 1.5 mm
J3
13 pin removable terminal board - connections for control and accessory inputs
1-2 Electric lock - 12 V AC output with maximum connectable load of 15 W controlling the electric lock for
approx. 1.5 seconds in the opening stage.
3-4 Flashing LED, 24 V DC - two-wire cables with min. section 1 mm
5-4 Warning light - 24 V DC output with maximum load of 3 W for gate warning light.
6-10 Pedestrian opening start (N/O).
J4
7-10 24 V power supply for ACCESSORIES.
8-10 Opening safety device (safety contact N/C).
9-10 Closing photocells input (N/C safety contact)
11-12 STOP (N/C safety contact) to stop wing.
13-12 START (N/O) starts wing opening and closing.
removable connector for primary transformer (230 V AC)
J6
removable connector for optional battery recharging card
J7
to use two 12 V 1.9 A/h or 1.3 A/h batteries (not supplied with the unit)
removable terminal board - connections to encoder for motor 2
J9
removable terminal board - connections to encoder for motor 1
J10
connector for integrated receiver memory module
J12
removable terminal board - 230 V AC phase-neutral-earth connection
M1
power supply connected warning light
DL1
24 V DC battery connection
BATT
connector for integrated receiver
JRX
10-pin connector for PL-ECO receiver
CN1
3-pin Aprimatic connector for accessories; connection for radio card compatible with UNICO receiver - GSM
CN2
- decoder access control -
terminal board - antenna for integrated receiver
CN3
2 faston connectors for secondary transformer (21 V AC)
FS1
FS2
fuse for primary transformer protection -
F1
fuse for external accessory protection (24 V DC) -
F2
fuse for electronic circuit protection -
F3
four LED display units (7 segments and one dot) to display parameters and parameter values
DS1
DS2
DS3
DS4
3 programming buttons:
YELLOW ESC to exit the current process (and can be used to show the connections on the display) (and can be used
before self-teach process to drive motor 1 when manned)
BLUE scroll to scroll through the options available (and can be used before self-teach process to drive motor 2
when manned)
OK to access basic programming and to confi rm the option displayed
RED
3.1

SYSTEM START-UP: SELF-TEACH

When all the connections have been completed you must run the self-teach cycle before putting the
system into service. The entire procedure must be completed otherwise the automation will not work.
During the self-teach procedure the unit acquires or updates the following installation data to ensure correct
functioning:
stroke span;
wing opening/closing direction;
number of operators connected;
profi les of the current absorbed by the operators;
presence of incremental encoders fi tted on motors;
. DO NOT use other types of fl ashing light.
2
- 24 -
2