General Safety Requirements; Dec La Rat Io N O F Resp O N Sib Ilit Y B Y T H E M An U F A Ct U Re R; L Im It S O F U Se An D P Re Ca U T Io N S F O R Saf Et Y; Electrical Safety - CTX NEXT Manual De Instalación

GENERAL SAFETY REQUIREMENTS

Declaration of responsibility by the manufacturer
CERTIKIN will be held responsible for the safety, reliability and performance of the equipment only if used in
compliance with the following conditions:
Limits of use and precautions for safety
The unit is intended solely for the purpose for which it was built. Any other use is considered improper
and therefore dangerous. The manufacturer declines any liability in the event of alterations and/or electrical
and hydraulic connection errors due to failure to comply with the instructions contained in the installation,
use and maintenance manual. Failure to comply with these instructions voids the warranty immediately.

Electrical safety

In order to guarantee conditions of utmost safety for the operator, we recommend that all of the indications listed
in this manual are respected.
Safety of the operative environment
The panel of the GUARDIAN NEXT control unit is protected against the infiltration of liquids. Do not expose the
unit to dripping or splashes and do not use the unit in environments featuring these risks. Units in which liquids have
penetrated accidentally must be switched off, cleaned and checked immediately by qualified and authorised personnel.
After completing the installation and calibration operations, it is recommended to put the protective panel of the
GUARDIAN NEXT control unit back in place.
ENGLISH
42
Calibration, modifications or repairs must be carried out by qualified personnel, specifically authorised
•
by CERTIKIN
Opening of the equipment and access to its internal parts may only be carried out by qualified
•
technicians for maintenance and specifically authorised by CERTIKIN.
The environment in which the equipment is used must comply with safety regulations.
•
The electrical connections of the environment must be carried out according to regulations and must be
•
perfectly efficient.
Replacements that can be carried out on parts of the equipment and accessories must be done so with
•
others of the same kind and of the same characteristics.
The use and maintenance of the equipment and of relative accessories must be carried out in
•
compliance with the instructions indicated in this manual.
This manual must always be kept integral and legible in all parts.
•
Before use, check that all the safety requirements have been met. The unit must not be powered
•
by or connected to other units until the safety conditions have been met.
Power the equipment exclusively using network tension according to specifications
•
(100÷240VAC 50/60Hz)
Replace damaged parts immediately. Cables, connectors, accessories or other parts of the
•
equipment that may be damaged or not working correctly must be replaced immediately. In this case
contact your nearest authorised technical assistance centre.
Only use accessories and peripheries specified by CERTIKIN. In order to guarantee all of the safety
•
requirements, it is important to make exclusive use of the accessories specified in this manual which
have been tested in combination with the equipment. The use of accessories and consumption
materials of other manufacturers or not specifically recommended by CERTIKIN. will not guarantee the
safety and correct operation of the equipment. Only use peripherals that comply with the regulations of
their specific categories.