Setting The Set-Points - CTX NEXT Manual De Instalación

Setting the set-points

Below is the sequence of operations for setting the set-point values relating to a measurement channel. A similar
sequence applies to all other measurement channels that may be present depending on the version of the instrument
purchased.
Touch the MEASUREMENT (e.g.
1 pH) key to access its configuration
menu.
CONFIGURING THE SETPOINT
Touch the PRESS TO SET key to
1
access the menu
Touch the PRESS TO SET key to
2
access the menu of relay 1.
Press the Acid+ON/OFF key to access
3 the Output and Dosing Modes
configuration menu.
OUTPUT and DOSING MODES:
- Alkaline+ON/OFF
- Acid+ON/OFF
- Alkaline+Proportional
- Acid+Proportional
- Disabled
ENGLISH 61