General Safety Rules; Work Area Safety; Electrical Safety; Personal Safety - Makita 6905B Manual De Instrucciones

ENGLISH
SPECIFICATIONS
Capacities
No load speed (RPM)
Impacts per minute
Max. fastening torque
• Due to our continuing programme of research and development, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.

GENERAL SAFETY RULES

WARNING:
Read all instructions. Failure to follow all
instructions listed below may result in
electric shock, fire and/or serious injury. The
term "power tool" in all of the warnings listed
below refers to
(corded) power tool or battery-operated
(cordless) power tool.
SAVE THESE INSTRUCTIONS

Work area safety

1. Keep work area clean and well lit. Cluttered and
dark areas invite accidents.
2. Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.
3. Keep children and bystanders away while
operating a power tool. Distractions can cause you
to lose control.

Electrical safety

4. Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools. Unmodified plugs and matching outlets will
reduce risk of electric shock.
5. Avoid body contact with earthed or grounded
surfaces such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
Model
Bolt size
Square drive
Overall length
Net weight
GEA001-3
your mains-operated
6905B
M12 - M20 (1/2" - 3/4")
12.7 mm (1/2")
1,700/min.
2,000
294 N.m (217 ft.lbs)
270 mm (10-1/4")
2.7 kg (6 lbs)
6. Do not expose power tools to rain or wet
conditions. Water entering a power tool will
increase the risk of electric shock.
7. Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges or
moving parts. Damaged or entangled cords
increase the risk of electric shock.
8. When operating a power tool outdoors, use an
extension cord suitable for outdoor use. Use of a
cord suitable for outdoor use reduces the risk of
electric shock.

Personal safety

9. Stay alert, watch what you are doing and use
common sense when operating a power tool. Do
not use a power tool while you are tired or under
the influence of drugs, alcohol or medication. A
moment of inattention while operating power tools
may result in serious personal injury.
10. Use safety
protection. Safety equipment such as dust mask,
non-skid safety shoes, hard hat, or hearing
protection used for appropriate conditions will
reduce personal injuries.
11. Avoid accidental starting. Ensure the switch is in
the off-position before plugging in. Carrying
power tools with your finger on the switch or
plugging in power tools that have the switch on
invites accidents.
12. Remove any adjusting key or wrench before
turning the power tool on. A wrench or a key left
attached to a rotating part of the power tool may
result in personal injury.
13. Do not overreach. Keep proper footing and
balance at all times. This enables better control of
the power tool in unexpected situations.
2
6906
M16 - M22 (5/8" - 7/8")
19 mm (3/4")
1,700/min.
1,600
588 N.m (433 ft.lbs)
327 mm (12-7/8")
5 kg (11 lbs)
equipment. Always wear eye