BDS Maschinen MAB 485 Instrucciones De Manejo página 19

K e y - t y p e d r i l l c h u c k
CS Unitec, Inc. • Phone: 203-853-9522 • Toll-free: 800-700-5919 • Email: info@csunitec.com
M A B 4 8 5
In s e r t i n g t h e t o o l
Push the key-type drill chuck (H) onto the tapered
‹
mandrel (F) and push the combination into the morse taper
(3) of the machine .
Open the drill chuck and insert the tool into the drill chuck .
‹
Close the drill chuck by hand and then tighten the drill chuck
‹
with the chuck key .
R e m o v i n g t h e t o o l
Unlock the drill chuck with the chuck key and remove the
‹
tool .
W A R NING
R i s k o f i n j u r y !
► Tighten the drill chuck only with the chuck key provided .
► Always remove the chuck key from the drill chuck after
tightening or loosening .
www.csunitec.com
P r e p a r a t i o n s
1 9