Weber Summit E-470 Guia Del Propietario página 10

A) Locate hose retention clip (1) on regulator hose. Secure into slot (2) on underside of
tank scale.
m WARNING: The hose must be secured to the tank scale with the
Hose Retention Clip. Failure to do so could cause damage to the
hose resulting in a fire or explosion which can cause serious
bodily injury or death, and damage to property.
Some LP tanks have differing top collar assembles. (The top collar is the metal
protective ring around the valve.) One series of tanks mount with the valve facing front
(3). The other tanks mount with the valve facing away from the fuel scale (4). WEBER
recommends the use of tank manufacturer's Manchester and Worthington, with a 47.6
lb water capacity. Other tanks may be acceptable for use with the appliance provided
they are compatible with the appliance retention means (see illustrations).
The LP tank is installed inside the base cabinet, on the tank scale (right side).
B) Open base cabinet doors.
C) Loosen tank lock wing nut. Swing tank lock up (5).
D) Turn the LP tank so the opening of the valve is either to the front or side of the
WEBER gas grill.
E) Lift tank up into position on the tank scale (6).
F) Swing the tank lock down. Tighten the wing nut.
Connect The Hose To The Tank
A) Remove the plastic dust cover from the valve.
B) Screw the regulator coupling onto the tank valve, clockwise, or to the right. Hand-
tighten only (7).
Note: This connection tightens clockwise and will not allow gas to flow unless the connection
is tight. The connection requires tightening by hand only.
m WARNING: Do not use a wrench to tighten the connection. Using
a wrench could damage the regulator coupling and could cause
a leak.
10
GAS INSTRUCTIONS
3
1
5
6
2
4
5
7