Sear Station Burner Manual Ignition; To Extinguish; Using The Sear Station - Weber Summit E-470 Guia Del Propietario

SEAR STATION BURNER MANUAL IGNITION

m DANGER
Failure to open the lid while igniting the grill's burners, or not
waiting five minutes to allow the gas to clear if the grill does
not light, may result in an explosive flare-up which can cause
serious bodily injury or death.
The SEAR STATION burner, has an on or off control setting. To ignite the SEAR STATION
burner, you must first ignite the two adjacent main burners.
Adjacent Main Burner Snap Ignition
Note: Each main burner control knob snap igniter creates a spark from the igniter electrode
to the burner lighting tube. You generate the energy for the spark by pushing in the control
knob and turning it to START/HI. This will ignite each individual burner.
A) Open the lid (1).
B) Verify each main burner that is adjacent to the SEAR STATION is lit by visual
inspection of a flame (2).
C) Put match in the matchstick holder and strike match.
m WARNING: Do not lean over open grill.
D) Insert matchstick holder and lit match down through cooking grates and
FLAVORIZERbars to ignite the SEAR STATION burner (3).
E) Push the SEAR STATION control knob in and turn it to the ON position (4).
m WARNING: If the burner does not light, turn the burner control
knob to OFF and wait five minutes to let the gas clear before
you try again.
Note: See "MAINTENANCE" for burner removal and cleaning
procedure.
◆

TO EXTINGUISH

Push in and turn each burner control knob clockwise to OFF position. Turn gas supply
off at the source.
◆

USING THE SEAR STATION

Your WEBER gas grill includes a sear burner for searing meats such as steak, poultry
parts, fish, and chops.
Searing is a direct grilling technique which browns the surface of the food at a high
temperature. By searing or browning both sides of the meat, you will create a more
desirable flavor by caramelizing the food surface. Searing will also enhance appearance
of the meat with sear marks from the cooking grates. This, along with the contrast of
textures and flavors, can make food more interesting to the palate.
The SEAR STATION burner has an on or off control setting that works with the two
adjacent main burners. With the sear and adjacent burners, you can effectively sear
meats while using other cooking areas for grilling with moderate heat.
Before searing food, you should turn all of the main burners on HI for 15 minutes to
preheat the grill. Note: Always grill with the lid closed to allow for maximum heat and to
avoid flare-ups.
Once the grill is preheated, turn the outer burners off or down to low. Leave the center
two burners on HI and ignite the SEAR STATION burner.
Place the meat directly over the SEAR STATION. You will sear each side anywhere from
one to four minutes, depending on the type and thickness of the meat. You may turn the
food a quarter turn to make crossing sear marks (1) before you sear the other side in
the same manner.
Once you are done searing the meat, you can finish grilling it by moving it to a more
moderate heat over the outside burners to achieve the desired doneness.
As you gain experience in using your SEAR STATION, we encourage you to experiment
with different searing times to find results that work best for your taste.
SEAR STATION IGNITION & USAGE
◆
1
3
The grills illustrated
in this Owner's Guide
may vary slightly from
the model purchased.
4 BURNER
SEAR METHOD
Food is placed in the area of intense heat between the lit burners
1
4
2
WWW.WEBER.COM 23