Removing The Harness - Inglesina Newton 1.2.3 Ifix Manual De Instrucciones

HARNESS ADJUSTMENT
fig. 19 Loosen the harness using the release button (J).
fig. 20 Important: never pull the harness by gripping it from the shoulder
straps (G).
fig. 21 Bring the child seat to its most vertical position, using the lever (F).
fig. 22 Using the rear lever (D), adjust the height of the headrest (A) in relation
to the height of the child.
fig. 23 For correct adjustment, the harness must pass at the level of the child's
shoulders.
Caution: the shoulder belts must not run behind the back of the child or at
ear height or above the ears.
fig. 24 Pressing the red button (P1), release the central buckle (P).
fig. 25 Once the child is settled, adjust the harness, passing it over the
shoulders and pelvis.
fig. 26 Insert the two connectors (P2) into the central buckle until you hear
them CLICK correctly into place.
fig. 27 Tension the harness correctly around the child, taking care not to
secure it too tightly.
Caution: always leave a minimum space between the harness and chest of
the child (1 cm approx.).
fig. 28 If necessary, loosen the harness using the release button (J).
fig. 29 To release the harness, press the red button (P1) on the central buckle
(P).
RECLINING THE CHILD CAR SEAT
fig. 30 Using the lever (F), recline the child seat to the desired position.
REMOVING THE CHILD CAR SEAT FROM THE VEHICLE
fig. 31 To remove the child seat from the car, loosen the Top Tether harness
(K1) using the release device (K2), then detach the Top Tether hook (K) from the
hook on the car.
fig. 32 Pressing both release buttons simultaneously (N), detach the Isofix
connectors (L).
fig. 33 Finally, remove the child seat from the car seat.

REMOVING THE HARNESS

• Do not use the car's two-point or lap safety belt.
fig. 34 Bring the child seat to its most vertical position, using the lever (F).
fig. 35 Lengthen the harness as far as possible using the release button (J).
fig. 36 Important: never pull the harness by gripping it from the shoulder
straps (G).
fig. 37 Pull out the metal connector (I1) at the back and, if necessary, lengthen
it further using the button (J); then remove both the back straps from the
connector itself.
fig. 38 Place the metal connector (I1) in the rear instruction manual
compartment (R).
fig. 39 Remove the back straps from the slots on the child seat (I2).
fig. 40 Using the rear lever (E), raise the headrest (A) to the maximum
HOW TO CONVERT THE CHILD CAR SEAT
FROM GR. 1 TO GR. 2/3 (15-36 KG)
37