Service; To Clean The Tester - AgraTronix 08150 Manual De Instrucciones

TO CHECK BATTERY POWER LEVELS AND REPLACE BATTERIES
1. The tester is powered with two
9 volt alkaline batteries. The left
battery (A) powers the backlight
circuit. The right battery (B) powers
the system.
2. The tester will fl ash a BATTERY
LOW message if system bat-
tery needs replacing when unit is
turned on. It will not say this for the
backlight battery. In the event that
the backlight battery is low, the
backlight will not work.
3. At any time, select BATTERY from
main menu and press TEST to
display the percentage available
for both batteries.
4. The tester system functions will
operate if no backlight battery is
installed or if it is low.
5. SYSTEM BATTERY LOW message will be
presented when unit is turned ON and the
battery is 10% or less usable.
NOTE: If the backlight battery is fresh and
the system battery needs replacing, the backlight battery can be used to
operate the system by moving it to the system battery location.

TO CLEAN THE TESTER

Remove cap and wipe out inside of the tester with a dry paper towel.
NOTE: Grain may become lodged in threads of cap and should be removed
with a small blade.

Service

A - Light Battery
B - System Battery
C - Main Menu
D - Test Button
E - Select Button
13