Tabla de contenido
Publicidad
3 mm
4 mm
Ø
1
2.5 mm
1
2
English
Model 04441000 only:
Install the handle.
Tighten the screw using a 3 mm Allen wrench.
All other models:
Install the handle.
Tighten the handle screw using a 2.5 mm Allen
wrench.
Reverse the cartridge
If the valve opens through hot, reverse the
cartridge.
Close the stops using a 4 mm Allen
wrench, or turn the water off at the
main (1).
Unscrew the nut (2).
Use the following procedure to
remove the cartridge.
Do not attempt to pry the cartridge
from the function block by using
a screwdriver, or damage to the
cartridge will result.
Place the handle on the cartridge stem.
Turn the handle counter-clockwise approximately
¼ turn after hitting the stop.
Publicidad
Tabla de contenido
