WEG CFW500 Guía De Instalación, Configuración Y Operación página 7

Ethernet Communication Plug-in Module
GND
+24 V
Figure 1: Signals of the control connector
Besides the control connections, the module has a
connector for Ethernet interface, which follows the 100
Base-TX Fast Ethernet standard.
The location of the DIP-switches to select the kind of the
analog input and output signal and the termination of the
RS485 and network can be better viewed in Figure A2
on page 19. To use the analog inputs and/ or outputs
with signal in current, switch S1 and related parameters
must be set as indicated in Table 3 on page 8.
For further details about the control connections see
CFW500 | 7