Tabla de contenido
Publicidad
WARNING:
To avoid all risks for young children, install the appliance
with the lowest heating element at least 600 mm from
(Fig. 5).
IMPORTANT
The radiator must be fastened to the wall and adjusted
so that the fan heater is against the wall as shown in
Do not adjust the radiator in such a way that
This could obstruct the air intake, causing the fan heater
to overheat and the "FILTER" light to come on.
Never install the appliance:
- immediately below or in front of a power socket or
a junction box (Fig. 7)
-
-
or pressure vessels.
Make sure there are no pipes or electric wires in
the wall which could be damaged while mounting
the appliance.
3.1 WALL MOUNTING
Make sure the screws and anchors included in the
mounting pack are suitable for the type of wall on
which you are mounting the appliance. If in doubt,
During installation, make sure the power cable is
disconnected from the power line.
The mounting kit includes:
A - 2 x top mounts, 85 mm long
A - 2 bottom mounts, 53 mm long
B - 2 top brackets, 85 mm long
C - 2 inner spacers
D - 2 outer spacers
E - 2 screw caps
F1 - 60 mm screws
F2 - 12 mm screws
F3 - 35 mm screws
G - 4 x anchors
MOUNTING TEMPLATE
If the installation template is not printed on the back of the
box, use the measurements given in Table 1, respecting the
and 5.
If the installation template (Fig. 8) is printed on the back of
the box, this respects measurements A and B given in Table 1.
Open up the box completely and rest it against the wall and
The minimum recommended distance between the bottom
holes on the wall, drill and insert the anchors (G). With the
mounts (A) with the hole facing upwards and the two 53 mm
long bottom mounts (A) with the hole facing downwards.
Fix the top part of the towel warmer, inserting it between the
inner spacer (C) and the outer spacer (D), making sure that the
deepest part of the inner spacer (C) is facing towards the inside
of the radiator and the "sx" symbol on the outer spacer (D) is
facing outwards.
Then screw the entire assembly to the bracket without tight-
ening fully. Insert the bracket (B) onto the mounts (A) and
fasten it using the 12 mm screws (F2). Fully tighten the 35 mm
the screw cap (E) provided. The appliance is now mounted on
the wall. Check that the minimum distance of 11 cm from the
3.2 ELECTRICAL CONNECTIONS
WARNING
To be installed by a specialised engineer in accord-
ance with the applicable standards in the country
concerned.
When the appliance is installed, make sure the power
is off and the mains switch is in the "O" position.
The appliance requires a 230 V ~ 50 Hz power supply.
Make sure the power line is appropriate for the data
given in table 1.
13
Radiator
elements
Radiator
elements
With a pencil, mark the four
GB
Publicidad
Tabla de contenido
