Intended Use - DeWalt DFD270 Manual De Instrucciones

or AC ........... alternating current
or AC/DC .... alternating or
direct current
...................... Class II
Construction
(double insulated)
n o ....................... no load speed
n ......................... rated speed
...................... earthing terminal
..................... safety alert symbol
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
SPECIFICATIONS
Tool body Machined steel, covered with plastic and glass
fiber housing.
Fasteners length Must use direct fasteners 1/2" (13 mm) to 2-7/8"
(72 mm) total length.
Tool length 18-1/2" (47 cm)
Load type Short .27 caliber (6.8/11) in a 10 load safety strip.
Power level Brown (2), Green (3), Yellow (4), Red (5)
Fasteners type .300" head direct drive fasteners
8 mm head direct drive fasteners
1/4"-20 threaded studs
Weight (without Tool with single shot nose piece.
pin/loads)
Tool with magazine nose piece.
COMPONENTS (FIG. A)

WARNING: Never modify the powder‑actuated
tool or any part of it. Damage or personal injury
could result.
Refer to Figure A at the beginning of this manual for a
complete list of components.

Intended Use

Your DFD270 powder‑actuated fastening tool is a power
adjustable, low velocity, fully‑automatic .27 caliber tool
which can be used to install .300" head drive fasteners,
8 mm head drive fasteners and 1/4"‑20 threaded studs, up
to 2‑7/8" (72 mm) in total length.
The DFD270 is designed for high speed and repetitive
volume fastening applications in concrete, certain masonry
materials, and A 36 steel. It includes a power adjustment
dial, allowing the operator to effectively decrease the power
level of the load being used.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
Your powder‑actuated fastening tool has been designed for
professional use.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
..................... visible radiation
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
..................... read all
documentation
7.1 lbs (3.23 kg)
7.6 lbs (3.45 kg)
ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal
injury, remove loads and fasteners before
making any adjustments or removing/installing
attachments or accessories. An accidental
actuation can cause injury.
Attaching a Single Shot Nose or Magazine
to the Tool (Fig. B, C)

WARNING: When replacing the single shot nose
or magazine, ALWAYS make sure the bumper is
properly installed.
1. Make sure there are no fasteners or powder loads in
the tool.
2. With the tool facing away from the operator and
any bystanders, remove the single shot nose
magazine 9 by pressing the single shot nose release
button or magazine release button
7
unscrewing it.
Fig. B
6
7
Fig. C
10
3. Before switching to the single shot nose or
magazine, remove the piston and check for wear.
Refer to Replacing the Piston and Bumper
under Maintenence.
4. Insert the piston into the tool. Be sure to push
it all the way back into the tool. Ensure piston is
positioned correctly.
5. Screw the single shot nose or magazine onto the tool
until the single shot nose release button
release button 10 engages.

CAUTION: If the release button does not engage,
take the tool to a D
for repairs.
English
6
and
10
9
7 or magazine
WALT authorized service center
e
or
5