Mounting The Camera - D-Link DCS-6004L Guía De Instalación Rápida

MOUNTING THE CAMERA

Please refer to the steps below to assist you with mounting the camera. We suggest that you
configure the camera before mounting.
1
2
3
4
5
DCS-6004L / DCS-6005L
Step 1:
The camera needs to be separated from the mounting base to
expose the holes in the mounting base. Remove the camera head
from the mounting base by firmly holding the camera with the D-Link
logo facing you and then sliding the mounting base towards you.
Step 2:
Place the mounting base alignment sticker where you want to
position the camera. Depending on the material of the wall or ceiling,
use proper tools to drill two holes where you placed the alignment
sticker. If the wall is made out of concrete, drill the holes first, then
insert the plastic anchors to support the screws.
Step 3:
Place the mounting base over the holes that are in the wall. Make
sure to align the mounting base holes with the holes in the wall. Use
the supplied screws to attach the mounting base to the surface of
the wall.
Step 4:
With the D-Link logo facing you, reattach the camera to the mounting
plate by sliding the camera towards you until it locks into position.
Step 5:
Adjust the direction of the camera as desired by rotating it.
5