Mounting The Camera - D-Link DCS-4612EK Manual Del Usuario

Mounting the Camera

Note: It is highly recommended that you configure
and test your camera before mounting it.
The DCS-4612EK, DCS-4614EK and DCS-4618EK
can be installed on the ceiling or wall. The
process is identical for both cameras.
Mounting the Camera
1. Use the included T10 or T15 screwdriver
to unscrew the three screws on the dome
cover and remove it.
Figure 7: Removing the Cover
4
2. Press the sides of the plastic lining and
gently lift it to remove the lining from
the camera.
Figure 8: Removing the Lining
3. Place the installation sticker on the ceiling
or wall. Using a 4 mm drill bit, drill three
holes 30 mm deep into the wall or ceiling.
Drive the plastic wall anchors into the holes.
Figure 9: Attaching the Camera
4. Insert three mounting screws into the
holes in the base of the device. Place the
device against the mounting sticker and
screw it in to attach it to the wall or ceiling.
Quick Installation Guide