Bluetooth (Handsfree Calling And Music Streaming); Bluetooth Operations; About Bluetooth Icons; Installing The Microphone - Sony DSX-S310BTX Manual De Instrucciones

Bluetooth (Handsfree calling
and Music streaming)

Bluetooth Operations

To use the Bluetooth function, the following
procedure is necessary.

1 Pairing

When connecting Bluetooth devices for the
first time, mutual registration is required. This
is called "pairing." This registration (pairing)
is required only for the first time, as this unit
and other devices will recognize each other
automatically from the next time. You can
pair with up to 9 devices.
2 Connecting
After pairing is made, connect this unit and
the Bluetooth device. Depending on the
device, connection automatically made along
with the pairing.
3 Handsfree calling/Music streaming
You can make/receive a handsfree call, or
listen to audio through this unit.
For details of usable devices, visit the following
support site.
Support site
http://esupport.sony.com
http://www.sony.com/mobileAV

About Bluetooth icons

The following icons are used by this unit.
Lit:
Flashing:
None:
Lit:
Flashing:
None:
Lit:
Flashing:
None:
Lit:
Flashing:
None:
32
Bluetooth signal is on.
Pairing is in standby mode.
Bluetooth signal is off.
Connected to a cellular
phone.
Connection is in progress.
No cellular phone is
connected for handsfree
calling.
Connected to a device.
Connection is in progress.
No device is connected for
music streaming.
Some unread SMS
messages exist.
A new SMS message has
been received.
No unread SMS messages
exist.
Signal strength status of
connected cellular phone.*
Remaining battery status of
connected cellular phone.*
* Turns gray without handsfree connection. Differs in
the case of a cellular phone.

Installing the microphone

To capture your voice during handsfree calling,
you need to install the microphone (supplied).
For details on how to connect the microphone,
refer to the supplied "Installation/Connections"
guide.
Pairing
First, register ("pair") a Bluetooth device
(cellular phone, etc.) and this unit with each
other. You can pair up to 9 devices. Once pairing
is established, there is no need for pairing again.
1
Press and hold (BLUETOOTH).
" " flashes (pairing is in standby mode).
2
Set the Bluetooth device to search for
this unit.
A list of detected devices appears in the
display of the device to be connected. This
unit is displayed as "Sony Automotive" on
the device to be connected.
DR-BT30Q
Sony
Automotive
XXXXXXX
3
If passkey* input is required on the
display of the device to be connected,
input "0000."
XXXX
This unit and the Bluetooth device memorize
each other's information, and when pairing is
made, this unit is ready for connection to the
device.
Input passkey.
"0000"