Safety Measures; Cleaning And Maintenance - Sinmag Europe SE-921F Manual De Instrucciones

ENG

10. SAFETY MEASURES

• I n order to avoid damage to cables and hoses, you should keep these
away from the floor.
• Make sure that the machine is switched off when you clean, maintain or
repair it.
• The setting of the thermostat and the pulsation must not be changed
during operation.
• Please do not put water or oil on the upper side of the oven.
• I n order to avoid injuries or quality loss of the product, do not touch the
oven during operation.
• Do not touch the oven during operation.
• Do not cover the exhaust opening.
• Please do not clean the oven before it has cooled down.

11. CLEANING AND MAINTENANCE

A. Please switch off all switches after use.
B. Pull out the damp key after daily use in order to remove damp from
the baking chamber.
C. Use a brush to clean the rests inside the baking chamber.
D. Clean the outer side of the oven with a dry cloth, do not was hit with
water. The left and right plate and the back board should be remo-
ved, before the baking chamber is cleaned. We recommend the use
of a cleaning product.
E. Check the over door, the digital panel and the other parts daily to
ensure proper functioning.
F. Check the cable and hoses every once in a while to see if there is no
leak or other damage before you start using the oven again.
10
SINMAG EUROPE BVBA