Pc Interface Mode - Grundfos DIT-IR Installation And Operating Instructions

5.3 PC interface mode

To scroll until the PC interface is set, press the [Select] key.
5.3.1 Connection to a PC
Connect the PC and the DIT-IR module port with a USB cable.
5.3.2 Data transmission to a PC
See also section 5.1 Data transmission
After software installation (section 4.2 Software installation),
a folder containing a software shortcut will automatically be
generated on the desktop.
After the software has been started, the following option window
appears. A user name can be entered, the required language
(German/English) can be chosen and the type of data report
required can be selected.
If no DIT-IR is connected when the software is started, the status
message shown below appears after clicking [OK].
Connect the DIT-IR, select the appropriate interface and click
[Refresh].
The following status message appears:
Option Excel
If the DIT-IR has been found, a window opens. Enter the file
location and name.
After confirming the location, the operating interface of the
software opens:
In this window, the transmitted data can be viewed and stored.
DIT-IR settings can be changed. See section 5.3.3 Configuration
of the DIT-IR settings.
Simultaneously, an Excel template (result template) opens
automatically, using the chosen language. The transmitted data
will be stored in this sheet.
If the print command on the photometer has been pressed, the
transmitted data can be seen in the operating interface as well as
in the Excel template. The data will be saved automatically to the
assigned location under the chosen name.
Data acquisition operating interface:
9