Ductwork Installation; Wiring To Power Supply; Install Accessories; Final Assembly - KOBE CH-101 Serie Instrucciones De Instalación Y Manual De Operación

Ductwork Installation

7. Use 8" round steel pipe (follow building codes
in your area) to connect the ducting transition
on the hood to the ductwork above. Use duct
tape to make all joints secure and air tight.
Refer to Figure 5.

Wiring to Power Supply

6$)(7< :$51,1*
RISK OF ELECTRICAL SHOCK. THIS RANGE
HOOD MUST BE PROPERLY GROUNDED.
MAKE SURE THIS IS DONE BY SPECIALIZED
ELECTRICIAN IN ACCORDANCE WITH ALL
APPLICABLE NATIONAL
ELECTRICAL CODES. BEFORE CONNECTING
WIRES, SWITCH POWER OFF AT SERVICE
PANEL AND LOCK SERVICE PANEL TO
PREVENT POWER FROM BEING SWITCHED
ON ACCIDENTALLY.
8. Connect the electrical wires.
-
Connect three wires (black, white and
green) to house wires and cap with wire
connectors.
black to black, white to white, and green to
green as shown on Figure 6.
-
If necessary to hide the electrical wire
connections, push wires back into the
wiring box. Access the wire connections
underneath the hood. Make sure wires do
not slip between motor or any moving parts
to prevent any damage.

Install Accessories

9. Attach Oil Tunnel. Refer to Figure 7.
10. Refer to Figure 8. c Slide the baffle filter into
the hood. d Push the baffle filter upward. e
Slide forward. f Pull downward. g Fit into
place.
11. Repeat for all baffle filters and spacers. Refer
to page 18.
12. Install heating lamps (not included), 120 Volts
175 Watts max. each.

Final Assembly

13. Turn power ON in control panel.
lights and fan operation.
14. Make sure to leave this manual for the
homeowner.
AND
Connect according to color:
Check all
Figure 5
Figure 6
LOCAL
Figure 7
Figure 8
8