Wall Mount Installation - KOBE CH-101 Serie Instrucciones De Instalación Y Manual De Operación

***This installation only applied with the purchase
of an optional duct cover:
Preparation before Installation
NOTE: TO AVOID DAMAGE TO YOUR HOOD,
PREVENT DEBRIS FROM ENTERING
THE VENT OPENING.

Decide the location of the venting pipe from the
hood to the outside. Refer to Figure 9.

A straight, short venting run will allow the hood
to perform more efficiently.

Try to avoid as many transitions, elbows, and
long run as possible.
performance of the hood.

Use duct tape to seal the joints between pipe
sections.

If necessary, prepare back wall frame with
cross framing lumber for secure installation.

Using references
measurements on page 17-18, decide the level
of the lumber. Refer to Figure 10.
Hood Preparation before Installation
x
Temporarily wire the hood to test for proper
operation before installing.
x
Important: Peel protective film off the hood
and the duct cover (if any).
x
Attach ducting transition to hood exhaust with
six (3/16" x 1/2") screws (included). Refer to
Figure 11.
x
If necessary, attach two rubber stands
(included) with adhesive tape (included) to the
back corners of the hood.
x
Use twelve (3/16" x 1/2") screws (included) to
attach the two
(included) to the back of the hood. Refer to
Figure 12.

WALL MOUNT INSTALLATION

This may reduce the
on Table 2
hood-mounting brackets
Figure 9
Figure 10
and
Figure 11
Figure 12
9