Ductwork Installation; Install Accessories - KOBE RA-028 Serie Instrucciones De Instalación Y Manual De Operación

Ductwork Installation

5. Use aluminum or steel pipe to connect the
6" round plastic exhaust on the hood to
the ductwork above.
make all joints secure and air tight. Refer
to Figure 6.
Wiring to Power Supply
SAFETY WARNING
RISK OF ELECTRICAL SHOCK.
RANGE HOOD
GROUNDED. MAKE SURE THIS IS DONE
BY SPECIALIZED
ACCORDANCE WITH
NATIONAL AND
CODES. BEFORE CONNECTING WIRES,
SWITCH POWER OFF AT SERVICE PANEL
AND LOCK SERVICE PANEL TO PREVENT
POWER FROM BEING
ACCIDENTALLY.
6. Connect the electrical wires.
-
Connect three wires (black, white and
green) to house wires and cap with wire
connectors. Connect according to color:
black to black, white to white, and green
to green as shown on Figure 7.
-
If necessary to hide the electrical wire
connections, push wires back into the
wiring box. Access the wire connections
underneath the hood. Make sure wires
do not slip between motor or any
moving parts to prevent any damage.

Install Accessories

7. Refer to Figure 8.
into the hood.
upward.
downward.
8. For bottom casing, repeat above steps.
Refer to Figure 9.
Use duct tape to
MUST BE PROPERLY
ELECTRICIAN
ALL APPLICABLE
LOCAL ELECTRICAL
SWITCHED
Slide the baffle filter
Push the baffle filter
Slide forward.
Fit into place.
Figure 5
THIS
Figure 6
IN
ON
Figure 7
Pull
7