Wall Mount Installation - KOBE Premium Serie Instrucciones De Instalación Y Manual De Operación

***This installation required to have Duct Cover Model No. CH1120DC-1.
Preparation before Installation
NOTE: TO AVOID DAMAGE TO YOUR HOOD,
PREVENT DEBRIS FROM ENTERING THE
VENT OPENING.
-
Decide the location of the venting pipe from the
hood to the outside. Refer to Figure 8.
-
A straight, short venting run will allow the hood to
perform more efficiently.
-
Try to avoid as many transitions, elbows, and long
run as possible. This may reduce the performance
of the hood.
-
Temporarily wire the hood to test for proper
operation before installing. If the hood does not
operate, check the circuit breaker or house fuse.
If the hood is still not working, disconnect power
supply and check the continuity of all wire
connections.
-
Peel protective film off the hood (if any).
-
Use duct tape to seal the joints between pipe
sections.
-
If necessary, prepare back wall frame with cross
framing lumber for secure installation.
references on Table 2 and measurements on page
21-23, decide the level of the lumber. Refer to
Figure 9.
Vent option installation
CAUTION:
USE HAND TOOLS ONLY. DO NOT
OVER TIGHTEN SCREWS. IT MAY CAUSE DAMAGE TO
THE HOOD.
1. Choose the require vent option. Some installation
screws are already pre-attached to hood. Refer to
Figure 14. Please use Screws Package {L} with
pre-attached screws for wall mount installation.
2. For 6" Round vent installation only:
- The 6" exhaust is already attached. (Figure 10)
Align and secure the 6" Round Plastic Collar {F}
to two screws on hood. Follow instructions in Step
5 to attach Hood Mounting Bracket {M} and two
Duct Cover Support {N} (Figure 14)
3. For Top 3-1/4" x 10" vent installation only:
-
Remove attached 6" exhaust and discard. (Figure
10) Keep 13 screws to install 3-14" x 10" exhaust
& vent cover.
- Align Top Vent Cover {E} and 3-1/4" x 10"
Exhaust {D}. (Figure 11) Skip to Step 5 to attach
Hood Mounting Bracket {M} and two Duct Cover
Support {N} using 14 screws (13 screws taken
from 6" exhaust. (Figure 14)

WALL MOUNT INSTALLATION

Using
12
Figure 8
Figure 9
Figure 10
Figure 11