Boiler Status; User Mode; Boiler Switch On - BOREAL HYDROBOREAL Serie Instrucciones De Instalación, Uso Y Mantenimiento

EN
8. Press again in the middle of the symbol "+", that will move now to the down right side of the screen as below image:
9. After pressing this point again the calibration process will be completed and display will go to the main screen.
Check now, pressing the screen, that the display now has more accurately in the assigned orders.
9.6.

BOILER STATUS

With the boiler running, pushing only once the key
status.
Display
Exhaust T. [°C]
Buffer temperature [°C]
Pressure(mbar)
Air hux
Fan speed[rpm]
Auger [s]
Recipe [nr]
Production code. 510-
Exhaust T. (º C)
Buffer T. (º C)
Pressure (mbar)
Air Flux
Fan Speed (rpm)
9.7.

USER MODE

Below is a description of the display in normal operation depending on the available functions.
9.7.1.

BOILER SWITCH ON

To switch on the boiler we have to push the key
start; we will see the message "Ignition"
The time of lighting process is several minutes. If after this time the flame is not present the boiler will automatically show the alarm "Er12"
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
Touch the cross by stylux.
X1: 749 Y1: 764
Touch the cross by stylux.
X1: 749 Y1: 764
X2: 455 Y2: 561
in the display, we can access to the next menu which provides technical information of the boiler
Description
28 Smoke temperature of the boiler
26 Sanitary water temperature in the tank
601 Working pressure of the boiler (water pressure)
70 Air flow
1250 Smoke extractor fan speed
1.2 Auger activation time
1 Comsbution order selected (Only 1)
Model code (Only for internal use)
Information
28
26
601
70
0
during three seconds. First the boiler will make an initial "check up" and then the lighting process will
52
Information
Auger (s)
Recipe (nr)
Prod. Code: 510
1.2
1
1111
HYDROBOREAL