Servicing And Care; Burner Cleaning; Cleaning The Ash Pan; Ash Pan Door And Combustion Chamber Door Seals - BOREAL HYDROBOREAL Serie Instrucciones De Instalación, Uso Y Mantenimiento

11. SERVICING AND CARE

The maintenance operations guarantee a proper operation of the product over its lifetime. Not making these maintenance operations will affect the
safety of the product.
EN
11.1.

BURNER CLEANING

In the Hydroboreal 23 and 27 models, even though the burner cleaning is automatic, it is necessary to carry out a weekly cleaning.
- Use a vacuum to clean the ashes in the burner.
- Remove the burner from its place and unblock the holes.
- Hoover the ashes which is inside the burner housing.
ceramic cord and self-adhesive fibre at the same Boreal distributor where you bought your boiler.
These operations should be done exclusively by an authorised technician.
11.4.

CLEANING THE CHIMNEY

When the pellet is burnt slowly, it produces tar deposits and other organic vapours that combined with the humidity to
create soot (creosote). An excessive accumulation of soot may cause problems in the smoke outlet and the flue may
catch fire if not maintained.
The cleaning of the boiler chimney should only be made when the equipment is cold. A chimney sweep should perform this task and, at the same time,
examine the smoke duct (it is recommended to write down the dates of every cleaning and keep a register of them).
11.5.

CLEANING THE GLASS

IMPORTANT:
Clean the glass only when it is cold in order to avoid possible explosion. You can use specific products. You can find vitro
ceramic-cleaning product in the same Boreal distributor where you bought your stove.
BREAKAGE OF GLASSES. The glasses, as they are vitro ceramic, resist until 750ºC and they are not subject to thermal shocks.
The breakage can only be caused by mechanical shocks (crashes or violent closing of the door, etc). Therefore, its replacement is not
included in the warranty.
11.6.

EXTERNAL CLEANING

Do not clean the external surface of the boiler with water or abrasive products because they may damage the stove. Use a feather duster or a moist rag
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
In the case of model Hydroboreal 23A and 27A, as it has an automatic cleaning system, the burner
cleaning must be carried out when it is observed that the holes in the base are obstructed and do not
allow the passage of the oxygen for a correct combustion.
11.2.

CLEANING THE ASH PAN

The ash pan should be emptied when necessary. The boiler should not be operated without having
the ash pan in position. In the event of using olive stone as fuel, the amount of ashes will be higher
than those produced by pellet. In this case the ash pan cleaning should be done more frequently.
In the Hydroboreal A model there is a capacity viewer, in case you notice that the level is very high,
it is necessary to proceed with the emptying of the ashes.
11.3.

ASH PAN DOOR AND COMBUSTION CHAMBER DOOR SEALS

The seals ensure the boiler air tightness and, thus, a proper
performance.
It is necessary to check them regularly; if they are worn-out or
damaged they should be replaced immediately. You can find
62 HYDROBOREAL