Tabla de contenido
Publicidad
English
Technical Information
Recommended water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Flow rate - showerhead
Flow rate - handshower
*Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
• This showerpipe is for use with shower heads
rated at 1.5 GPM (5.7 l/min) or higher.
• The showerhead is for use with an automati-
cally compensating valve rated at 1.5 GPM
(5.7 l/min) or lower.
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, profes-
sional plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
• The installation dimensions shown in this
installation instruction are ideal for people of
approximately 6' in height. The dimensions
can be changed if required. In this case, the
minimum ceiling height of 92¾" from the
standing surface, and all other measurements,
must be changed.
• The installer must ensure that the entire area of
the wall to which the mounting plate is to be
This unit meets or exceeds the following:
•
•
•
2
15 - 75 PSI
120° - 140° F*
2.0 GPM max.
1.85 GPM max.
ASME A112.18.1
CSA B125.1
Listed by IAPMO for use in the US
and Canada
145 PSI
176°F*
mounted, is flat (no protruding grout joints or
tiles). He should also make sure that the wall
is strong enough to support the showerpipe.
• The enclosed screws and anchors are suitable
for a solid surface wall. If installing in a fiber-
glass or acrylic shower unit, install header
boards at the mounting points.
• This showerpipe requires showerpipe rough
16181181(not included).
• To prevent scald injury, the maximum output
temperature of the shower valve must be
no higher than 120°F. In Massachusetts,
the maximum output temperature can be no
higher than 112°F.
• Keep this booklet and the receipt (or other
proof of date and place of purchase) for
this product in a safe place. The receipt is
required should it be necessary to request
warranty parts.
Publicidad
Tabla de contenido
